Horse Illustrated Magazine

From Equine Guelph

With cooler, darker days ahead – and more pressure on heating and lighting systems – the risk of barn fires increase. So, now is the time for your annual combustible clean-up! Combustibles are everywhere and unavoidable around the horse farm, but your management of them can considerably reduce the risk of a barn fire.

To help you learn more about the combustible hazards in your barn and evaluate the safety of your facility, go to Equine Guelph’s Barn Fire Prevention online tool. The interactive assessment tool asks 20 questions about inside and outside of your barn and takes five minutes to complete.

The chart below outlines some of the common fuel sources that burn rapidly once ignited and discusses best practices for prevention.

“Once you have reduced your risk taking care of combustibles, inspect all possible sources of ignition,” says Equine Guelph director, Gayle Ecker. Electrical malfunctions are a primary ignition source for many fires including barns.

To reiterate, farm buildings can have an increased fire risk in winter when heating and electrical systems are more heavily taxed for heating and lighting. Portable heaters are a risk as are other appliances not intended for agricultural use. When not in use, electrical equipment should be unplugged and properly stored away. It is important not to let water bucket heaters run dry. Once empty, the continuous heat can melt the bucket resulting in ignition of stall bedding and hay.

An annual electrical inspection, completed by a qualified electrician familiar with livestock barns, is highly recommended to check for signs of deterioration or corrosion. The Electrical Safety Authority has stringent requirements for installation of electrical equipment in animal confinement areas. Have any issues that are found repaired without delay.

Jim Zyta, Vice President Loss Prevention Heartland Farm Mutual provided the following tips: For additional protection against fire, especially in the animal housing area, consider arc-fault protection on 15 and 20amp circuits and receptacles. This is especially important if your wiring is recessed within barn walls and above ceilings. Arc-fault protection could prevent a fire due to loose connections or rodent damage saving your building and much more!

When using 240 volt “approved barn heaters” consult with your Electrician and ESA Inspector. It is a best practice to hardwire these units directly to a 30amp circuit avoiding a receptacle connection. These 30amp/250V receptacles are notorious for burning up! Always maintain clearances to combustibles as per manufactures installation guidelines. Zyta says Heartland is happy to partner with Equine Guelph on this initiative, “We are helping barn owners protect what they value the most.”

For more tips on fire prevention and to complete interactive activities inside and outside your barn, visit the Barn Fire Prevention Tool, sponsored by Heartland Farm Mutual.