With proper use and maintenance, your clippers can last for many years. To keep them in top condition, follow the manufacturer’s instructions for that particular clipper and lubricate regularly according to instructions. It sounds obvious, but follow the directions carefully. For example, some manufacturers recommend using a cooling spray during use; others do not.
Care of the blades is important if you want them to last and hope to get a smooth cut.
If you only start out with two types of blades, purchase a set of #10 blades, which are most commonly used for body clipping, and a set of #30 blades for finer trimming.
When buying blades remember: Choose high grade steel which contains chromium and a high carbon content to retain sharpness longer. Ice-tempered steel blades coated with titanium are harder than average blades which translates to longer life and less sharpening. Some premium blades have an additional chromium coating to resist outer surface corrosion.
Blades can have a long life if properly stored and cared for. Ken Aldrich Of Big Sun Equine Products in Ocala, Florida, offers tips on caring for clipper blades.
- Use a blade and wash as directed rather than use kerosene or fuel.
- Store them properly in a blade holder with oil in it, or in a plastic bag which contains lubricant. An inexpensive way to store blades is wrapped in a sock sprayed with WD-40.
- Always have an extra set of sharp blades on hand and switch out blades if they become hot while clipping.
- Lubricate blades during clipping.
- Make sure the horse is clean before you start.
- Have blades sharpened whenever they begin to dull. (In addition to slowing the job and delivering less than quality results, dull blades tug on the hair and make clipping uncomfortable for the horse.)
Cynthia McFarland is a freelance witer based in Florida.
Good advice,however as service manager for Wolseley Horse clippers of England, I would advise that whilst using WD40 to protect blades from rust during storage is fine, never ever be tempted to use WD40 to lubricate clipper blades on the machine whilst clipping. Use only an oil recommended by the machine maker, this will save you from overheating and prematurely blunt blades..plus expensive repairs to your machine.
Whilst WD40 is fine to spray on blades when storing them, to prevent corrosion. Never be tempted to use it to lubricate the blades whilst running the machine. Only use proper clipper lube, which is designed for the purpose
Great article. I found it insightful.
This article some may find not as interesting as I do. I am a beginner at clipping my own horses and appreciate all the tips on clipping and clippers that I can find.
I have never clipped my horse. I was just curious.